ADJ X-move LED plus Spezifikationen PDF herunterladen (Seite 6)

A.D.J. Supply Europe B.V. – www.americandj.eu – X-Move LED Plus™ Instruction Manual Page 6

SET UP (continued)

Special Note: Line Termination.

When longer runs of cable are used, you may need to use a terminator on

the last unit to avoid erratic behavior. A terminator is a 110-120 ohm 1/4 watt resistor which is connected

between pins 2 and 3 of a male XLR connector (DATA + and DATA -). This unit is inserted in the female XLR

connector of the last unit in your daisy chain to terminate the line. Using a cable terminator (ADJ part number

Z-DMX/T) will decrease the possibilities of erratic behavior.

Termination reduces signal errors and avoids

signal transmission problems and interference.

It is always advisable to connect a DMX

terminal, (Resistance120 Ohm 1/4 W) between

PIN 2 (DMX-

) and PIN 3 (DMX +) of the last

fixture.

Figure 4

5-Pin XLR DMX Connectors. Some manufactures use 5-pin XLR connectors for DATA transmission in place

of 3-pin. 5-pin XLR fixtures may be implemented in a 3-pin XLR DMX line. When inserting standard 5-pin XLR

connectors in to a 3-pin line a cable adaptor must be used, these adaptors are readily available at most

electric stores. The chart below details a proper cable conversion.

Pin XLR to 5

Pin XLR Conversion

Conductor 3-pin XLR Female (Out) 5-pin XLR Male (In)

Ground/Shield Pin 1 Pin 1

Data compliment (- signal) Pin 2 Pin 2

Data True (+ signal) Pin 3 Pin 3

Not used Pin 4 – Do Not Use

Not used Pin 5 – Do Not Use

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Keine Kommentare

ADJ X-move LED plus Spezifikationen Seite 6